List of tools and Equipment used?
Open ended spanner, Digital Multimeter, Overall and safety boot.
Describe the process used in completing the task:
1. Test the battery of vehicle that get the voltage 12.45 V.
2. Take off the negative pole first, and put it on a plastic part.
3. Take off the positive pole, and put it on a plastic part.
4. Take off the top screw, then bottom screw.
5. Put the battery on the plastic bumper, and keep original position put on the grand.
6. Put back the battery to original position the vehicle.
7. Put back the positive pole first, and put back the negative pole.
8. Screw up bottom and top screws.
Consider Risk Assessment:
Flow Sparks
Reflect on activity:
Correct remove and refitting battery. when refitting battery, turn the screws to tighten and correct position is very important, to avoid battery movement. Fit Positive first (Red one), because it reduces the chance of shorting the battery out which could cause the battery to explode.
Start by taking removing the negative:
Once the negative terminal has been slackened remove it and tuck it away so it can't touch the terminal again whilst you are loosening the positive.
Remove the positive terminal connector (red wire) on the other end.
No comments:
Post a Comment